Paramtents
Technique ERW
Grade 16Mn, A53-A369, Q195-Q345
WT 0.75-8MM
Thickness 0.75 - 8 mm
Outer Diameter 21.3 - 273.1 mm
OD 21.3-273.1MM
Packging & Delivery
Min Order10 piece
Briefing
Detailed
Galvanized pipe
standerd ASTM A53 BS1387 GB/T3091-2001
Grader Q195 Q235 Q345 Q215
OD 21.3-273.1mm
WT 0.045-3inch
Length to your order or 5.6-6m
Application Stucture pipe
1. TOLERANCE
:a) On Specified OD + 0.5mm (Ovality 0.5mm)
:b) The Inside Diameter of ubes shall allow insertion of a guage of 37.7mm dia for a minimum length of 200mm.
:c) On Wall thickness -10%
:d) The mass deviation on a single tube shall not exceed -7.5% of the specified mass.
2. ENDS
: Cut cleanly and nominally square with the axis of the tube and free from excessive burrs.
3. PROPERTIES
:a) Chemical (Maximum) C - 0.20%, SI - 0.05%, MN - 1.40%, P - 0.04%, S - 0.045%, AL - Min. 0.02%.
:b) Mechanical = UTS - 340 to 520 N/mm2, YS - 235 N/mm2 (minimum) & %Elongation on 5.65 S0 - 24% (minimum).
4. FLATTENING TEST WELD AT 90 DEGREES (COLD)
a) For weld : Distance between the platens, measured under load is not greater than 75% of the OD of tube.
b) For Material :Distance Between the platens, measured under load is not greater than 60% of the OD of tube.
5. STRAIGHTNESS
: 1 in 500 (In 1 meter it should not exceed 3mm).
6. ZINC COATING
: Minimum local coating thickness on the outside surface 40 microns.
(GALVANIZING)
7. MARKING
: a) We can emboss mill sign "EN 39 UTP 3 or 4." online at every one meter interval over the length of pipe.
b) We can do online stencilling as per customer needs.
8. PACKING
: Hexagonal type.
9. MILL TEST CERTIFICATE
:We can issue a MTC, certifying that the tubes supplied comply with this Standard.
网络文化经营许可证:浙网文[2013]0268-027号|增值电信业务经营许可证:浙B2-20080224-1 2007-2024 Tradevv.com. All rights reserved.